The building drying process is a form of the building protection.

Since 1997 approx. 350 objects were fast dried by us with our micro wave technique.

The fast drying process by means of microwave engineering always presupposes the removal of the causes of the moisture penetration.
Advantages over conventional procedures:

• high drying effectiveness
• high penetration depth
• supports all conventional procedures
• purposeful treatment of damp ranges
• weather and temperature-independently
• small power requirement
• biological (thermal) effect

A goal was working with as large a number from microwave units as possible. By it responding surface achievements can be attained in relatively short time. The possible number is usually determined thereby by the current offer and by the surface size. As optimal for dwellings and smaller surfaces again and again the use of three units turned out. These can be used with the drying process of walls vertically or horizontal.


Fig. 1 shows 3 units in vertical arrangement as a tower.

Thus a work height of 1,20m is reached.


Fig. 2 shows 3 units in vertical arrangement as a tower.

Thus a work height of 0,80m is reached.


Fig. 3 shows the use of 6 units with the drying process of 80 cm strong mixture brick-work.

Condition here is the request of power.

Fig. 4 shows equipment horizontally working. This approach is of

importance particularly with the drying process of the first stone rows (to approx. 30 cm).

Fig. 5 shows the heat distribution in the field of work.